Page 10 of 10 FirstFirst ... 8 9 10
Results 91 to 92 of 92
  1. #91
    Might as well be part of the furniture.
    Join Date
    Jun 2013
    Location
    Bucks
    Posts
    3,197
    It took almost 10 minutes of twisting and gentle pushing for it to engage in the pump.

    Can take that long even for professionals. Now you can see why so many people get it wrong.

    Now fill the trans to the top mark and fire up the engine. Add more fluid until you get a CLEAN line on both sides of the dip stick. I have dipped and wiped over 20 times on some transmissions to get a clean line of the level.

    First trip around the block, dip the trans again.

    Hope this is not eggs and grandma....


    Seen a trans input shaft, seal and converter nose wiped out after a few hundred miles due to no dowels installed. They are there for a reason.
    Last edited by fad15; 22-07-19 at 12:16 PM.

  2. #92
    Might as well be part of the furniture.
    Join Date
    Jan 2014
    Location
    Outside the M25
    Posts
    1,132
    Had to find some where to put the induction so the top of the motor seemed like a good place.
    Getting there







Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •